Thingiverse
Tacticool Phone Holster (CASE SPECIFIC)
von PearlGreyMusic
13
Downloads
7
Likes
0
Makes
inspired by tacticool operater as heck gun holsters for cars, except its not for gun
I posted my phone holster design in some Facebook groups and people really liked it, so I am uploading the raw F3D files and .stls so people can either print it out if they happen to also have an iPhone 11 with the same case I do, or attempt to adjust the design for their own phone and case.
The cable I used is Anker Powerline Lightning Cable- the rubberized ends help make the force fit work. M3 screws are needed to put this together. You will need to drill 4 holes into the console panel- I recommend sticking on the "offset" piece as a hole guide and drilling using it.
I did not expect the demand for this. Again, it theoretically only works with my own case and similarly sized cases. This weekend, I might try to create a one-size-fits-all version, or finally learn SCAD and make a customizable version.
My phone case is 82mm wide, 12.5mm thick without the "finger hook" thingy, and 15.5mm thic
I posted my phone holster design in some Facebook groups and people really liked it, so I am uploading the raw F3D files and .stls so people can either print it out if they happen to also have an iPhone 11 with the same case I do, or attempt to adjust the design for their own phone and case.
The cable I used is Anker Powerline Lightning Cable- the rubberized ends help make the force fit work. M3 screws are needed to put this together. You will need to drill 4 holes into the console panel- I recommend sticking on the "offset" piece as a hole guide and drilling using it.
I did not expect the demand for this. Again, it theoretically only works with my own case and similarly sized cases. This weekend, I might try to create a one-size-fits-all version, or finally learn SCAD and make a customizable version.
My phone case is 82mm wide, 12.5mm thick without the "finger hook" thingy, and 15.5mm thic
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
