Taginn projectile

A solid taginn projectile that can be use to practice accurate firing of the taginn launcher.
You will have to weigh an original taginn projectile and adjust infill density to match the same weight. I recommend increasing wall line count to 6-8 and ceiling layer count to 8-10 for increased durability. These shells will eventually wear and break, particularly if you are launching them at a hard surface. DO NOT fire these at people or animals, or anything you do not want to break. (set up a cone in an open field or something)

Updates:
Mar. 24, 2022: rear/bottom of model hollowed out as cylinder to correct center of gravity, model will have to be printed with supports if printed vertically. additionally, should still be printed with about 20% infill and increase top layers to appx 10.