Thingiverse
Tail whee strut
por canamar
5
Descargas
2
Likes
0
Makes
The print comes out in two parts. the fuselage strut and the rudder clamp as seen in the image above. This is much like the one found on the hobbyzone super-cub. the rear of the fuselage strut is fits 18mm fuselages and the front fits 20mm fuselages. the whole for the landing gear is 2mm in diameter.
When printing, print it in the same orientation as in the first image, remember to use supports when printing it.
When printing, print it in the same orientation as in the first image, remember to use supports when printing it.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
