Thingiverse
Tailstock DRO
von stillyriver
1
Downloads
0
Likes
0
Makes
Designed for 32mm dia quill on G0602 lathe & it's cousins.
Clamp goes on end of quill. Hole on top reamed for 3mm dowel. Matching hole is drilled & reamed in end of 4" digital calipers. Hole slipped over dowel & calipers stuck to top of tailstock with carpet grade double sticky tape.
In this case I used a cheap, $7.65, plastic 4" calipers with a .1 mm resolution. The depth gauge & pokey bits were trimmed off. If it doesn't break I wont fix it with a trip to HF.
Clamp printed in PLA with 1.6mm walls & 10-15% fill. Takes M5 x 30 SHCS. C'bores'for hex nut or threaded inserts, your choice. 3mm or .125" dowel is also your choice.
Clamp goes on end of quill. Hole on top reamed for 3mm dowel. Matching hole is drilled & reamed in end of 4" digital calipers. Hole slipped over dowel & calipers stuck to top of tailstock with carpet grade double sticky tape.
In this case I used a cheap, $7.65, plastic 4" calipers with a .1 mm resolution. The depth gauge & pokey bits were trimmed off. If it doesn't break I wont fix it with a trip to HF.
Clamp printed in PLA with 1.6mm walls & 10-15% fill. Takes M5 x 30 SHCS. C'bores'for hex nut or threaded inserts, your choice. 3mm or .125" dowel is also your choice.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!