Thingiverse
tall foot
von Doc_Green
9
Downloads
6
Likes
1
Makes
i noticed that the fan grills were VERY close to the table that the printer was on. this does not provide good ventilation.
i found i could not print the small nibs used by the original poster. "tall foot" has a large 12.1mm post in the center / no nibs. the fit of the finished part is tight and may require a clamp to press into the center hole of the leg.
this will lift the printer by 5cm or 50mm
will fit lk4 pro & alfawise u30 / probably many others.
i found i could not print the small nibs used by the original poster. "tall foot" has a large 12.1mm post in the center / no nibs. the fit of the finished part is tight and may require a clamp to press into the center hole of the leg.
this will lift the printer by 5cm or 50mm
will fit lk4 pro & alfawise u30 / probably many others.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!