Thingiverse
Tamiya TT-02 Body Posts
von armegatron1
35
Downloads
23
Likes
0
Makes
A remix of DerBock's posts to more closely match the offsets of the originals to ensure body holes match up.
Printed 30% infill and at 0.2 with PLA
Note, to avoid as much 'junk' building up at the more complex mounting section on the bottom of the post I chose to print upside down with tree supports. This works great and only needs a slight trim of excess plastic on the oval mounting shape.
I've not track tested these but would imagine they'll be far weaker than a single moulded part so would suggest to print several as a spare.
Printed 30% infill and at 0.2 with PLA
Note, to avoid as much 'junk' building up at the more complex mounting section on the bottom of the post I chose to print upside down with tree supports. This works great and only needs a slight trim of excess plastic on the oval mounting shape.
I've not track tested these but would imagine they'll be far weaker than a single moulded part so would suggest to print several as a spare.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
