Tangrams & Case

Made them mainly to see if I could (very new to 3D modeling). I loved the set of Tangoes we had when I was a kid. I didn't have access to them when I was making this set of tiles but I found them after and these are slightly smaller than the tiles from that set. I made a case to go with it that has a sliding lid which clicks into place to secure the tiles. There is a diagram on the inside of the lid which helps indicate how the smaller tiles fit in

Sites are available online with the puzzles and you can print a set of tiles to play along! They're great for learning how geometric shapes combine to form new shapes and general problem solving/puzzling

With the listed settings, on a high-speed printer, the case and lid will print in about an hour
The tiles will print in about thirty-five minutes
The whole thing is about an hour and a half plus some finishing touches

Settings Notes:
I recommend a brim for the case and lid but the tiles shouldn't need it
I also recommend that the lid is p