Thingiverse
Tankstation Rc
von ModellflugDave
19
Downloads
8
Likes
0
Makes
Fuel Filler Pump holder
There is another one here on thingiverse but the Generator was not able to upload a usefull stl for it so i created my own one.
Also i created a canister top fits on ASPEN canisters or simillar ones with a 42x4 metric thread.
Printed in PETG for fuel constancy.
Pump is a regual one with dimensions 104 x 60 x 40mm
You will need:
For pump holder
1 x M3 x 15 Cap Head Bolt
1 x M3 Nyloc Nut
2 x M3 Washers
For top
1 x rubber gasket ring
2 x tank fittings
Enjoy !
There is another one here on thingiverse but the Generator was not able to upload a usefull stl for it so i created my own one.
Also i created a canister top fits on ASPEN canisters or simillar ones with a 42x4 metric thread.
Printed in PETG for fuel constancy.
Pump is a regual one with dimensions 104 x 60 x 40mm
You will need:
For pump holder
1 x M3 x 15 Cap Head Bolt
1 x M3 Nyloc Nut
2 x M3 Washers
For top
1 x rubber gasket ring
2 x tank fittings
Enjoy !
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!