Thingiverse
Tap Box
von Router
3
Downloads
2
Likes
0
Makes
7/12/19
I started using this box yesterday, and I must say there is room for improvement. The best way for me to take the taps out is to use a magnetic probe. This would work fine for me but I would like something that would work for everyone. So back to the drawing board. I'll see you very soon.
Original text
this is my first model after a very long break of 3d modeling. I want to start off with something simple. This is something I need in my tool box. I have 4 taps that I use for every day work and my biggest tap is a 3/8 inch and this box should work. I do use a 1/2 tap from time to time, but that is for a different set up.
I started using this box yesterday, and I must say there is room for improvement. The best way for me to take the taps out is to use a magnetic probe. This would work fine for me but I would like something that would work for everyone. So back to the drawing board. I'll see you very soon.
Original text
this is my first model after a very long break of 3d modeling. I want to start off with something simple. This is something I need in my tool box. I have 4 taps that I use for every day work and my biggest tap is a 3/8 inch and this box should work. I do use a 1/2 tap from time to time, but that is for a different set up.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
