Tap Handle
9
Downloads
1
Likes
0
Makes
Handle made for a keg tap.
Its a little bendy but holds up.
I printed laying down with supports, but vertical is possible too.
Not sure what orientation the threads print in best.
They were a little tight but if you go slow and back out a few times it should be fine.
Maybe use pliers with a cloth or tape so you don't scratch it too bad.
Its a little bendy but holds up.
I printed laying down with supports, but vertical is possible too.
Not sure what orientation the threads print in best.
They were a little tight but if you go slow and back out a few times it should be fine.
Maybe use pliers with a cloth or tape so you don't scratch it too bad.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
