Tape Edge Protector - Parametric

Parametric Tape edge protectorTwist Snap lock design keeps both halves together and reusable for the next roll.No hardware, No glue, No supportsTolerances are built into the model. No need to figure it out, Just enter the exact dimensions of your tape roll.Two separate pieces “A” and “B” to configure to your sizing.Models are available in Inches and Millimeters.I'm using these mainly for very sticky tapes that are usually stored in a Ziploc bag to keep dust and debris from sticking to the sides ( 3M Double sided tapes, 3M VHB, Alien Tape, etc.) Cleaned up my drawers a little bit. This could also be used for anything on a roll. I'd recommend a pair of calipers to take your measurements for best results. All the parts pictured were done in PLA. This model should work with any correctly calibrated material though. They were also printed with STLs generated by the customizer to ensure everything was working correctly. Smallest recommended sizes due to the geometry: ID (Inside Diame