Tape Measure Spool

Another tape measure spool. No supports required.

How to use:
- Insert the tape through the rotor's slot. Inserting the middle of the tape gives maximum winding efficiency (you only need to wind half of the tape's length).
- Then push the stator on top of the rotor until it clicks into the rotor.
- Hold the spool by the stator and wind the tape by turning the rotor.
- To extract the tape, either turn the rotor the other way round and pull the tape out through the stator's opening, or squeeze the lips at the top of the rotor and push it through the stator's top to separate it from the stator.

***Thingiverse required me to upload a .stl file. But this .stl file may probably not match your particular tape as tapes are not all the same. The enclosed .stl files fit a thin 150 cm tape of 19 mm width .***

***Unfortunately the Customizer will not work with my OpenSCAD source file (for reasons unknown). Therefore you have only one option for creating a customized .stl file matching the di