Tapo C110 Internal Camera Holder

After getting annoyed to have the camera in the way of the front door, I designed this internal camera mount for the V2.2 of the Tapo C110 and the Bambu Lab P1S. Neither drilling holes into panels, nor disassembly is needed.The version of the camera is (what I assume) V2.2 according to the sticker on the back of the board (see photo of step 5), and not V1 or V2 as categorized here in picture 4 (plastic of lens part is different). This is important because soldered components on the edges of the board might be different on other versions, where it slides into the case. You need to checked that in the marked areas in the photo so no tiny SMD components get damaged!Check out my growing variety of other uploads!Disclaimer: I can't be sure that this is not printed by people with two left feet as hands, so: Use at your own risk!Again this case is tested for Tapo C110 V2.2 . Using it for other versions without properly checking components might damage them when sliding into the case. Also