Tapo CCTV Holder

I made this to address the problem of eliminating the need to drill another hole/s for the CCTV cam to be screwed onto the ceiling or wall, as Tapo doesn't have a bulb version. I basically created an enclosure for the power adapter plugged into the AC female adaptor on the bulb socket. The lid of the enclosure also serves as the mounting point of the CCTV, so no need to put it somewhere else, and they're all located on the same point on the socket itself.

This is v1, and some significant changes must be made, like incorporating the bulb socket right into the print build, as there are no other areas on the socket where you can latch or hang on the enclosure, except the socket adapter. But as the bulb socket thread is too deep, the adopter female socket goes right through where the enclosure is supposed to be holding on to, depriving the latter of something to hold on to, thus needing an extension socket to use with a shallower socket thread, which is redundant but solves the limitation