Tarantula LED lights

LED light for TEVO Tarantula hotend and, to put a little light directly on your print and side light to attach it on upper or side extrusion profile with t-nuts.

Further informations about wiring and other diode voltage in README.txt and it the photos.

1st & 2nd part lips can be heated with solder iron to create a joint.

Side Light should fit in 2020 extrusion profile slot

Requires (both side and hotend light):
- 2x LED 3mm, 3.2V
- soldering iron and solder
- 2x 1m long 0.25- 0.5mm^2 wire
- 470 Ohm - 1kOhm resistor
- 2x 1cm of heat shrink
+bolt & 2020 t-nut for side light (you can print some if you like)

No supports are needed!
Layer = 0.2mm
Nozzle = 0.4mm

Print it just like it is already placed ;)