Thingiverse
Tarantula lower right bracket with vertical support
by 3DPModder
57
Downloads
14
Likes
2
Makes
Update Feb 8 2018: Finally got around to redesigning the right bracket to properly form to the right 40x20 profile and connect to the bottom frame.
----------------
Just a mirror of RuiJC's left bracket with the unneeded section in the rear removed as the two sides aren't completely symmetrical.
NOTE: I wasn't paying attention when I mirrored this STL to the fact that the right leg is 40x20mm, not 20x20 like the left leg, so the inner-most rear section (circled and X'd in black in photo) is left unconnected and has no purpose. I fixed the STL to remove that area and just used a bench grinder to correct my already printed bracket.
----------------
Just a mirror of RuiJC's left bracket with the unneeded section in the rear removed as the two sides aren't completely symmetrical.
NOTE: I wasn't paying attention when I mirrored this STL to the fact that the right leg is 40x20mm, not 20x20 like the left leg, so the inner-most rear section (circled and X'd in black in photo) is left unconnected and has no purpose. I fixed the STL to remove that area and just used a bench grinder to correct my already printed bracket.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
