Tarantula Pro ABL Add-on
door billkaroly
9
Downloads
11
Likes
0
Makes
Mount this on the left side of the fan shroud. Use the unused upper left screw hole to attach. If everything fits then I would use a little E6000 glue and attach it to the shroud using the screw. Should be an M3. I designed this to be as minimal as possible and get as close to the shroud as possible. The sensor should be centered on the nozzle at a distance of approx 53mm. This is using a 5V sensor I originally bought for a PRUSA i3 clone based on Thomas Sanladerer's work and I have not tested it.
ADDED: 18mm version. Thanks Rusty1955
DESIGNED IN TINKERCAD. It's rough but effective.
Print without supports.
Added Version 2. Attach to both top screw holes.
ADDED: 18mm version. Thanks Rusty1955
DESIGNED IN TINKERCAD. It's rough but effective.
Print without supports.
Added Version 2. Attach to both top screw holes.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!