MakerWorld
Sport & Outdoors
Go to Model
Target Darts Display Stand
348
Downloads
92
Likes
255
Makes
Target Darts Display StandPlease note: The slicer will tell you that the object has floating regions. You can ignore this message as it is modeled like this on purpose. In order to get the best possible top surface, ….. Since the outline height is less than the layer height, the outline layer is not printed. This causes the the top shell layer to be printed without any defects. Check out this reddit thread for more information. This… … would cause these surface defects: The above solution will give a clean black top surface: Filaments used:JAYO PLA+ BlackJAYO PLA White Size: 65mm x 53mm x 22mm Created with Autodesk Fusion.Printed on Bambu Lab A1 with AMS.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
