Targi + Expansion insert

Targi board game insert designed to hold both original game and the expansion. Box can fit sleeved cards (sleeves up to about 60 microns thick), I used Mayday standard sleeves. Card boxes have 1mm incline to prevent cards sliding out during the game.
All card boxes, silver and water token boxes have 0.5mm embossed labels to help sorting the components.

Resource and coins trays are ok with Geekup bits, tested by other users.

The insert fits in the Targi or The expansion game box without any gaps, so the pins on the component boxes are only meant to help position them on top of each other. Since all component boxes have different height and pin set, follow the placement instructions to pack the game box. You can rotate the boxes 180 degrees.
IMPORTANT: You might consider setting scale to 97% or 95% when printing. I printed my copy with 100% scale and gaps with the box are less than 2mm in total.

This is my first ever 3D design, so any comments and suggestions are welcome.

P