Tarkin Town House

This is a remix of an existing building from the "Imperial Resettlement Camp" collection.

I edited the "Town House" Object to hollow it out (using less plastic) and separated the roof and the house proper from each other.

Now the house can be printed in two parts that should take

* ~ 11 hrs @ 0.3mm layer height (10% infill) for the lower part of the house ( ~ 135 g of plastic)

* ~ 7 hrs @ 0.3mm layer height (10% infill) for the Roof of the house (~ 115 g of plastic)

The original would take ~ 20 hrs and 340 g of plastic to complete, vs my remix which takes ~18 hrs in 2 parts and 250g of plastic to complete (saves you 2 hrs and 90g of plastic).

They roof and body connect to each other with glue, no clips. You could probably just set the roof on top of the base, but there is currently nothing to hold it.