Tau Drone Antenna

This is an attempt to make a replacement Drone Antenna for the Tau Drones. There is always an issue running out of Drone Antennas if you want shield drones over some other drone. This is an attempt to allow you to make more of the specific part that is reverse compatible with the modern drone kits.

This is modeled off of an old drone Antenna around 2002 or so with an added curve of the updated drone designs due to the proportions looking a bit nicer.

IPT is attached if you want to modify it.

Print was in Hips with a .2 nozzle, it is pushing the resolution boundary so some post processing will be required, or printing this in Resin/higher resolution.

If you are printing with hips and use different material support. Make sure that the Hips never sits on the plate as your support material (PETG) requires a much lower baseplate temp. Make sure to have 1 or 2 layers of support between your part and the baseplate.

Antenna 1 has fine details at the base that are hard to print with FD