Thingiverse
Taz5 Bracket for DiiiCooler Duct
door KillaCycle
26
Downloads
15
Likes
0
Makes
Adapter for attaching DiiiCooler fan duct to Taz5 Lulzbot printer. Can use hex hotend or E3D hotend.
I really like the DiiCooler. It gives 360 cooling and lots of it. I made this duct from clear PLA so it would pass light though. The duct effectively blocks your view of the part, but if you make it from clear, you can at least get light enough to see when you peer between the fan duct and the table.
(See my Low Profile Heated Bed Tabs that you will also need if you install this duct.)
I really like the DiiCooler. It gives 360 cooling and lots of it. I made this duct from clear PLA so it would pass light though. The duct effectively blocks your view of the part, but if you make it from clear, you can at least get light enough to see when you peer between the fan duct and the table.
(See my Low Profile Heated Bed Tabs that you will also need if you install this duct.)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!