Thingiverse
TBS Crossfire Module protector
door mklimmert
89
Downloads
46
Likes
1
Makes
This TBS Crossfire Module Protector can be mounted on the aluminium bars of FrSky stand that most of us have. Just remove the 3 rods and slide the printed model over the stands.
It will be tight fit so glue is not needed.
It can be best mounted when you first heat the surface of the print where the stands will slide in. Just enough heat to make it a little bit flexible. Heat and feel it is felxible. Repeat this till it is flexible enough. It has to e flexible just a little bit. You can heat it with a hair dryer or a electric heat gun. PLA needs less heat then PETG!
The TBS Crossfire Module Protector has low profile and fits nicely around the TBS module. See photo taken from side. Because of its low profile the Taranis still fits in a case nicely. See photo.
I have stuck a Tesa Protect 8 mm on the module for extra damping. See transparent Tesa Protect.
It will be tight fit so glue is not needed.
It can be best mounted when you first heat the surface of the print where the stands will slide in. Just enough heat to make it a little bit flexible. Heat and feel it is felxible. Repeat this till it is flexible enough. It has to e flexible just a little bit. You can heat it with a hair dryer or a electric heat gun. PLA needs less heat then PETG!
The TBS Crossfire Module Protector has low profile and fits nicely around the TBS module. See photo taken from side. Because of its low profile the Taranis still fits in a case nicely. See photo.
I have stuck a Tesa Protect 8 mm on the module for extra damping. See transparent Tesa Protect.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!