TBS Gemini Perfect Hover Stand

Ok one thing that can be a little tricky is getting the Gemini in a perfect orientation to set level. This is due to no flat surfaces, except for the small area under the motors on the CF "legs".


I have just completed my design of the 3D printed Gemini leveling stand. It consists of a base with two circular posts which insert tightly into the holes underneath the center two motors in the CF frame. These posts press in until the frame rests against the larger diameter of the stand. When flush the printed base will provide an easier way to ensure the Gemini is in the proper orientation for setting level.


In front of the base is an arm with protruding stand-off with a recess for a standard 1/4-20 nut and large head machine screw. This screw can be threaded up or down, pressing against the bottom case (towards the front of the Gemini) until the motor shafts are perfectly vertical. If the 3D printed base is placed on a perfectly level surface, and the machine screw adjusted until