Thingiverse
TBS Mambo flat stand for modules
por IB-King
3
Descargas
5
Likes
0
Makes
This is super hard to put on. You will most likely need to take the kick stand off of your Mambo . Then turn the printed stand piece sideways and shove that sucker onto the kickstand leg. it was SUPER HARD for me. Then turn it back into the vertical orientation. Rinse and repeat, all set.
I've included a looser version, but I prefer the tighter one. even though it is SUPER HARD TO SLIDE ON.
Also PRINT IN TPU as there will be no way to install if it is a rigid material !!!
I think this would make great finger grips for large handed thumbers.
I've included a looser version, but I prefer the tighter one. even though it is SUPER HARD TO SLIDE ON.
Also PRINT IN TPU as there will be no way to install if it is a rigid material !!!
I think this would make great finger grips for large handed thumbers.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!