Thingiverse
TBS Source One V3 GPS Bracket
von Andrea_Botti
10
Downloads
9
Likes
0
Makes
UPDATE:
Released a second version of the mount, it's lighter and moves the connector to the inside of the frame instead of in front.
Pictures may not match the model anymore but it is very similar.
This is a small bracket which holds a 22x20 GPS unit on the side of a TBS Source One V3 drone frame.
This model can be printed with TPU but an easier and more rigid plastic like PLA or PETG is recommended since it's never subject to any kind of stress, due to the arms of the drone and the frame in general protecting it even in a heavy crash. If the ground manages to touch this bracket it probably means your frame disintegrated, so you'd have much bigger problems to worry about.
Released a second version of the mount, it's lighter and moves the connector to the inside of the frame instead of in front.
Pictures may not match the model anymore but it is very similar.
This is a small bracket which holds a 22x20 GPS unit on the side of a TBS Source One V3 drone frame.
This model can be printed with TPU but an easier and more rigid plastic like PLA or PETG is recommended since it's never subject to any kind of stress, due to the arms of the drone and the frame in general protecting it even in a heavy crash. If the ground manages to touch this bracket it probably means your frame disintegrated, so you'd have much bigger problems to worry about.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
