Thingiverse
TBS Source One V5 easy replaceable accessories
von Uno3000
1
Downloads
3
Likes
0
Makes
These are the 3D Printed Accessories for my analog FPV build using the TBS Source One V5 frame.
To avoid instability issues of screwing the motor guards to the arms and to simplify the process of replacing broken guards, they are designed to be locked in place by only a zip tie, connecting it to the cable guards.
Additionally a M3x6 screw is required to attach the FC case to the FC case mount. The mount can be secured to the cable guards by zip ties as well.
The rear component mount is designed to hold the following components:
* TBS Unify Pro32 including antenna
* GOKU GM10 V3 GPS module
* ELRS EP1 radio receiver
* Battery connector
Finally I added some aerodynamic offshoots here and there to make it look cooler and faster;)
To avoid instability issues of screwing the motor guards to the arms and to simplify the process of replacing broken guards, they are designed to be locked in place by only a zip tie, connecting it to the cable guards.
Additionally a M3x6 screw is required to attach the FC case to the FC case mount. The mount can be secured to the cable guards by zip ties as well.
The rear component mount is designed to hold the following components:
* TBS Unify Pro32 including antenna
* GOKU GM10 V3 GPS module
* ELRS EP1 radio receiver
* Battery connector
Finally I added some aerodynamic offshoots here and there to make it look cooler and faster;)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!