Thingiverse
TBS source two fairing WIP
von badenwest
1
Downloads
0
Likes
0
Makes
Fairings for TBS Source Two V0.1
Keep all the grass clippings and dirt out of your electronics.
clip onto the frame standoffs
One version with cutouts for PS915's cam mounts. will need support in that cutout section.
Because it is so thin you can print the non cut out version and just cut sections out with some sprue cutters.
Made to be minimal and light, quick to print, and easy to install/remove.
I haven't tried it yet but I am pretty sure the non cut out version can be printed in vase mode
Keep all the grass clippings and dirt out of your electronics.
clip onto the frame standoffs
One version with cutouts for PS915's cam mounts. will need support in that cutout section.
Because it is so thin you can print the non cut out version and just cut sections out with some sprue cutters.
Made to be minimal and light, quick to print, and easy to install/remove.
I haven't tried it yet but I am pretty sure the non cut out version can be printed in vase mode
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!