Teabag Dispenser

This is a remix of the top hanging dispenser by enFoo who kindly shared a step file so that it could be modified easily. This one is a bit larger at 69x79mm and has space for you finger to get at the next teabag. I put 2 on the buildplate, who needs only 1? I faced them to the left to get nicer overhangs on the opening, other directions give a rough surface. Feel free to reduce the layer height from 0.24 to 0.2mm, this may produce better overhangs. Print time for 2 holders is 3h33m with PLA. I used Sunlu Meta so yours will likely be different.