Tealight holder: drop

Tealight holder in the shape of a falling drop.

I first designed this (in Blender and Tinkercad) with a screw in-bottom. I then realised that screwing in and out was a bit difficult with the drop hanging in a window (for example) so I decided to redesign the drop to work with magnets.

I used magnets with a diameter of 6mm. They need to be glued in place.

Please note that you can only use electric tealights with this design or else the plastic will melt and your house burn down (worst case scenario).

I printed this in PLA. There's no need to use support.

I advice to use some kind of translucent filament. That's what I've been using.