TechBox

New request to remove power supply, replace old power switch with Ender 3 V2 version, remove RPi mount, and move the motherboard back. The request also included an 80mm fan on top - removing the PSU shrinks the top to around 55mm, so I put the fan on the back panel. The new main body is named TechBox Main Body Rev2.stl. FYI - both versions use the same front panel (TechBox Front Panel Fixed.stl). There is a new top panel for this new version (TechBox Top Panel Rev2.stl).

The screw holes for the front panel - main body were not lining up - that has been fixed - old file has been removed and new file name is TechBox Front Panel Fixed.stl.

Comments on my E4 Enclosure asked for a smaller case, just for the Ender 3 motherboard, power supply and a Raspberry Pi.
Any change requests - just comment.

Raspberry Pi mounts vertical to save space with 2.5mm screws
Creality 4.2.x board mounts to the bottom with 2.5mm screws
All remaining hardware is 3mm

The print dimensions for thi