Thingiverse
Technical Drawing Board Clip
door conorwalsh
0
Downloads
7
Likes
0
Makes
This print is a clip that is designed to stop a technical drawing board from slipping during use.
Each board requires two clips as shown in the pictures.
The board shown above is commonly used by Junior and Leaving Certificate Students in Ireland.
The clips work best on boards that have a bar with a diameter of just over 19mm.
I have included the original Solidworks files as well as the STL to allow you to modify this if desired. The clip is designed to work on tables up to 40mm thick.
The addition of the black rubber tape in the location seen above increases the grip of the clip to the table.
I designed this for my brother to use on his board while doing his Junior Cert Technical Graphics.
Each board requires two clips as shown in the pictures.
The board shown above is commonly used by Junior and Leaving Certificate Students in Ireland.
The clips work best on boards that have a bar with a diameter of just over 19mm.
I have included the original Solidworks files as well as the STL to allow you to modify this if desired. The clip is designed to work on tables up to 40mm thick.
The addition of the black rubber tape in the location seen above increases the grip of the clip to the table.
I designed this for my brother to use on his board while doing his Junior Cert Technical Graphics.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
