Technics Pin Attachment Bar

***** This is a SCALED DOWN model using Lego plate dimensions, so you will need to scale up the model by 320% before slicing *****

I needed a way to attach a model to Lego and this three hole bar gives a strong attachment point if you use 3L blue Lego pins to sandwich this bar between technic bricks or bars. I've included the OpenSCAD source code if you want to use it.

There is also a low resolution gcode file attached if you happen to have a CR-10 or equivalent cartesian printer which likes printing at 210 degree hotend on a 50 degree heated bed for the first layer, dropping to 190 degree hotend for the remainder @ 50mm/s (using Cura "Lightning" fill with thin walls). If so, it's a 9 minute print at the correct scale ready to go :-)