Teddy bear (Hueforge)

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size
You may print at higher layer heights below the Min Depth of 0.24mm
The Max Depth is 2mm and the Actual Depth is 1.6mm

Filaments Used:
PLA PolyTerra Charcoal Black Transmission Distance: 0.3
PLA Overture Matte White Transmission Distance: 3.7
PLA Sunlu Meta Grey Transmission Distance: 3.5
PLA Overture White Transmission Distance: 4.4
This print uses 4 unique filaments

Swap Instructions:
Start with Charcoal Black
At layer #8 (0.72mm) swap to White
At layer #9 (0.8mm) swap to Grey
At layer #14 (1.2mm) swap to White for the rest.