Thingiverse
Music
Voir le modèle
Telecaster Control Plate
6
Téléchargements
8
Likes
0
Makes
Was surprised there wasn't a telecaster control plate on here that was accurate.
I found one but the dimensions were quite off from US/MIM spec.
This is measured off my US Tele
There is a 1.5mm version and a 3mm version.
My factory one is 1.27mm but that was quite a bit too thin especially for 3D printing so I rounded up to 1.5mm.
The 3mm version is just there cause it's stronger in case you wanted it.
I found one but the dimensions were quite off from US/MIM spec.
This is measured off my US Tele
There is a 1.5mm version and a 3mm version.
My factory one is 1.27mm but that was quite a bit too thin especially for 3D printing so I rounded up to 1.5mm.
The 3mm version is just there cause it's stronger in case you wanted it.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
