Thingiverse
Music
Zum Modell
Telecaster Switch Cap
19
Downloads
18
Likes
0
Makes
Selector Switch Cap for a telecaster.
Make sure you dont print too hot or the tolerances will be too tight on the knob. Should be a little bit of an effort to get on. Use a small screwdriver or sweezers to widen the edge of the hole out a bit if its too difficult to press on.
Make sure you dont print too hot or the tolerances will be too tight on the knob. Should be a little bit of an effort to get on. Use a small screwdriver or sweezers to widen the edge of the hole out a bit if its too difficult to press on.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
