Telescope Cable Management

Note: Please read the post-processing section for instructions and precautions, since I'm not responsible for any damages that occur to your telescope:)

I designed this mount to manage cables on my iOptron CEM25 that connect to my PC and run up to the guide camera and DSLR. The cable mount is designed for a 90mm diameter tube (as in the physical diameter of the scope, not the aperture, its the same diameter that your scope rings are made for). I currently have it installed on a Celestron C80ED. There are 3 different pieces to the mount, the upper ring, lower ring, and the cable runner cover. I designed it so that the upper and lower rings are connected using 2 M3x12mm bolts going through the top ring and screwing into M3 nuts on the bottom ring. I chose to use M3's for the small size, as I designed this to print fast. There is also a nut insert on the bottom ring for attaching the cable runner using a M3x8mm bolt. The runner cover acts as a simple clamp to keep the cables in place (