Slicer Discord
Telescope Tripod Mount Support Pads  – 3D-printbaar model van Thingiverse Thingiverse

Telescope Tripod Mount Support Pads

door skislalom1
20 Downloads
12 Likes
0 Makes
Model downloaden
Persons who use portable astronomical telescope mounts need to make several adjustments to their telescope mounts in order to be polar aligned. This includes leveling tripod mount and pointing it toward polar north. In the past, I did this in my front yard (grass) every time I set up my GOTO telescope mount - usually in the dark. Since the mount wasn't exactly in the same position each night, it always needed to have time consuming leveling and alignment adjustments. This would take 10-15 minutes of my valuable viewing time. This could have been solved by marking a position on my driveway or sidewalk but I don't have a view of Polaris at those locations.

I solved that problem by using these tripod support pads. After setting up my tripod in the manner described above, I carefully marked the location of each leg. I then pressed one of these support pads into the ground at each of the tripod leg positions. Each pad is flush with the ground so that they are not obvious and they
Bron
Thingiverse
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie