Tello Drone LEM (Lunar Excursion Module)

Tello Lunar Excursion Module (LEM)

UPDATE When I first test flew this it didn't have the Nozzle in place. After attaching it I discovered it interferes with the Tello's altitude and stabilization system so it needed to go. At the same time I re-positioned the Tello more forward and modified the attachments to open up the view for the sensors. So if you downloaded the parts be sure the mount parts A,B and C are v2.


This little LEM tribute model is fun (and fragile) to fly. Based around the [Tello Drone](https://www.amazon.com/Quadcopter-DJI-Technology-Accessories-Controller/dp/B078YLX1XJ/ref=sr_1_2?keywords=tello&qid=1556337163&s=gateway&sr=8-2)

Depending on the filament you use - it may not survive a bad landing. I found the groovey looking gold filament to be more brittle than regular PLA.

- It requires CA glue and a couple of heavy duty paperclips.
- The frame can be printed without supports but that may vary depending on how good your printer is at doing bridges