Slicer Discord
Temperature & Humidity Station – 3D-Druckmodell von Thingiverse Thingiverse

Temperature & Humidity Station

von SSZCanada
2 Downloads
3 Likes
0 Makes
Zum Modell
Rotate the Weather-Top by 180 degrees when you print so the flat side is down.

The height is enough that you can use solder-free wires that come in most kits to plug in all modules to the Arduino Uno board.


Requires

Arduino Uno
0.96' 128x64 I2C OLED Display
DHT11 module
Wires


Rename - TempStation0.9.txt to TempStation0.9.ino :)


Hook up Screen to Ground / 5V / SDA / SCL
Hook up DHT 11 to Ground / 5V / Pin 7
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen