Temperature Calibration Test (Costumizable)

Based on > [Customizable Temp Calibration Tower](https://www.thingiverse.com/thing:915435) by [eibwen](https://www.thingiverse.com/eibwen/about)

Adds the ability to remove holes and create a text for your test material

USAGE:

1. Check your material recomended temperature range

2. Costumize your temperature tower with thinguivers costumizer adding 2 steps above and below the recomended temperature
(If your recomended temperature is 240-270 for example use 220-290 in steps of 10º)

3. Open your tower in cura or your slicer of choice and duplicate the tower with a short distance between them

4. In cura go to extensions > post-processing > modify gcode and add a ChangeAtZ trigger by height changing temperature onwards
(For other slicer software you must find yourself how to do this, share back if you do)

5. Print your towers

6. Sacrifice one of the towers by breaking up each section at half the temperature block and look for the first temperature where the laye