Thingiverse
temperature calibration
door Misc3D
155
Downloads
88
Likes
1
Makes
remix of the cubold mesh from reprapneo,
Print it with 0% infill and no solid top and bottom layers.
At layerhight 0,2mm every 50 layer (10mm) should the temperatureswitch of 3°C be.
Print it with 0% infill and no solid top and bottom layers.
At layerhight 0,2mm every 50 layer (10mm) should the temperatureswitch of 3°C be.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
