MakerWorld
Electronics
Zum Modell
Temperature Controller 230V heating and cooling
12
Downloads
3
Likes
2
Makes
DescriptionA basic case for for a W3230 temperature controller. It uses standard sockets so that it can be used in various ways.After printing, connect all the wiring and snap the module + sockets in place, run the sensor wire out through the hole on the front of the case. I put a knot right behind the hole as a strain relief for the sensor wire. The lid closes with M4x15 countersunk bolts.You can use this temperature controller for cooling or heating anything as long as it has a 230V schuko/euro plug. Technically you can switch anything up to 2200 Watts, but it's probably better to not drive the relay at max. Materials used:ControllerInput SocketOutput SocketBolts
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
