Thingiverse
Temperature test - PLA version
von Webberen
1.4k
Downloads
814
Likes
15
Makes
This is a test which can be used to determine the best temperature setting for your PLA filament.
It starts with 190°C and goes up 5°C for every 15mm.
Use the .gcode version directly, for built in tweaks.
Or
Use the .stl version, if you wish to tweak the setting yourself, in cura (or your slicer of choice)
I hope you enjoy this DIY build/design.
For more follow me at INSTAGRAM- TWITTER and YouTube - @webberen
MakerSPACE #by #webberen
It starts with 190°C and goes up 5°C for every 15mm.
Use the .gcode version directly, for built in tweaks.
Or
Use the .stl version, if you wish to tweak the setting yourself, in cura (or your slicer of choice)
I hope you enjoy this DIY build/design.
For more follow me at INSTAGRAM- TWITTER and YouTube - @webberen
MakerSPACE #by #webberen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!