Thingiverse
Temperature tower PLA (220° - 180°)
von Boby71
26
Downloads
21
Likes
0
Makes
Temperature tower model for PLA.
Notice: You need to set different temperatures manually in the slicer!
Each cube section of the tower is 20mm tall - if you print at 0,2mm resolution (recommended), you need to define a temperature change every 100 layers!
Notice: You need to set different temperatures manually in the slicer!
Each cube section of the tower is 20mm tall - if you print at 0,2mm resolution (recommended), you need to define a temperature change every 100 layers!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!