Thingiverse
Tenkara Spool with removable face
door TMIB
17
Downloads
7
Likes
0
Makes
There's a few Tenkara spools already on Thingiverse. Most of them had an inner spool diameter too small to fit on the handle of my Ito rod. I made this one in OpenScad, so that you can easily modify the code to change the center diameter. I also made it so that one side is printed separately. You can glue it on for a permanent attachment, but I found that this is not needed- there's a nice friction fit between the pieces. This also makes it very easy to glue a strip of craft foam around the spool to help act as a cushion for the line.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!