Thingiverse
Tensioner Knob
von Thirkell
15
Downloads
8
Likes
0
Makes
Tensioner knob for M3 Screws/bolts.
Intended for use with belt tensioners, extruder tensioners or generally anywhere you would rather use your hand than a screwdriver.
Ensure that you print it the correct way up, there is a 1 layer thick solid section to support the hole. It is otherwise symmetrical.
Insert a M3 nut in one side, if you do not have hex head screws, and tighten all the way to the end.
Version 1 can be found here: http://www.thingiverse.com/thing:561529
Intended for use with belt tensioners, extruder tensioners or generally anywhere you would rather use your hand than a screwdriver.
Ensure that you print it the correct way up, there is a 1 layer thick solid section to support the hole. It is otherwise symmetrical.
Insert a M3 nut in one side, if you do not have hex head screws, and tighten all the way to the end.
Version 1 can be found here: http://www.thingiverse.com/thing:561529
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
