Thingiverse
Terminal Block Fuse
von alex79
1
Downloads
2
Likes
0
Makes
A Custom fuse wire holder to create a low power fuse. I needed a fuse to test some equipment and so i created this.
The two posts hold the fuse wire. Follow the pictures for first wiring the two posts. A 0.6 - 1mm wire is wraped around the post. This is then fed through the lower hole and bent to be fed back through the connector under the larger screw opening.
happy printing
The two posts hold the fuse wire. Follow the pictures for first wiring the two posts. A 0.6 - 1mm wire is wraped around the post. This is then fed through the lower hole and bent to be fed back through the connector under the larger screw opening.
happy printing
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
