Thingiverse
terminal connector block
door krikey
16
Downloads
4
Likes
0
Makes
After adding the DeWalt D26200 to my X-Carve, I needed to extend the mains supply using a new piece of flex. I made this model to suit my purposes.
The box walls are 3mm thick and act like clamps on the flex cable. There are two central pins that hold a 3 terminal block in place.
If you liked my design and want to show your appreciation,why not leave a small donation of a £/$/€ or two through the blue TIP BUTTON on the left.
The box walls are 3mm thick and act like clamps on the flex cable. There are two central pins that hold a 3 terminal block in place.
If you liked my design and want to show your appreciation,why not leave a small donation of a £/$/€ or two through the blue TIP BUTTON on the left.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
