Thingiverse
Tesla Coil Winder
por laptopdr
25
Descargas
19
Likes
0
Makes
Brackets, crank and coil holders to wind Tesla coil secondary coil by hand. Is especially made for using Everbuilt extension drain pipe as a former for the coil. Home Depot Store SKU #1000050266 .
Just enlarge the holes with a 5mm or 7/32" drillbit and screw a couple of 12-24 x 1.25" screws into the brackets and holes.
Use 30 gauge magnet wire which will give you 1000 turns coil. 4 ounces of that wire is enough for it.
Can be 3D printed with PLA+.
You'll also need a stand for the magnet wire spool, which I might upload separately later.
Just enlarge the holes with a 5mm or 7/32" drillbit and screw a couple of 12-24 x 1.25" screws into the brackets and holes.
Use 30 gauge magnet wire which will give you 1000 turns coil. 4 ounces of that wire is enough for it.
Can be 3D printed with PLA+.
You'll also need a stand for the magnet wire spool, which I might upload separately later.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!